2.6.23-rc2 3com vortex boot g

2.6.23-rc2 3com vortex boot g

[Pete Clements]

Fyi. Seeing the below on boot (first is UP, second SMP system).

from my logs,
23-rc1-git10 was ok
sorry, did not run git11 
23-rc1-git12 first shows up


eth0:  setting half-duplex.
WARNING: at kernel/irq/resend.c:70 check_irq_resend()
 [<c012e51b>] check_irq_resend+0xab/0xc0
 [<c012df59>] enable_irq+0x99/0xa0
 [<c01f72cb>] vortex_timer+0x26b/0x3d0
 [<c0122d3b>] hrtimer_run_queues+0x1b/0x140
 [<c01f7060>] vortex_timer+0x0/0x3d0
 [<c0117611>] run_timer_softirq+0x101/0x150
 [<c012648f>] tick_handle_periodic+0xf/0x70
 [<c014d33e>] sys_fstat64+0x1e/0x30
 [<c01144b2>] __do_softirq+0x42/0x90
 [<c0114526>] do_softirq+0x26/0x30
 [<c01045e7>] do_IRQ+0x47/0x80
 [<c011a0c2>] sys_rt_sigprocmask+0x62/0xd0
 [<c0102a2f>] common_interrupt+0x23/0x28
 =======================
NET: Registered protocol family 10


eth2:  setting half-duplex.
WARNING: at kernel/irq/resend.c:70 check_irq_resend()
 [<c014218b>] check_irq_resend+0xab/0xc0
 [<c0141d18>] enable_irq+0xc8/0xd0
 [<f8839a1b>] vortex_timer+0x27b/0x3f0 [3c59x]
 [<c0134baa>] hrtimer_run_queues+0xca/0x150
 [<f88397a0>] vortex_timer+0x0/0x3f0 [3c59x]
 [<c0127b46>] run_timer_softirq+0x116/0x180
 [<c0124262>] __do_softirq+0x82/0x100
 [<c0124317>] do_softirq+0x37/0x40
 [<c01125c7>] smp_apic_timer_interrupt+0x57/0x90
 [<c0101a70>] default_idle+0x0/0x40
 [<c010385c>] apic_timer_interrupt+0x28/0x30
 [<c0101a70>] default_idle+0x0/0x40
 [<c0101a9f>] default_idle+0x2f/0x40
 [<c0101044>] cpu_idle+0x74/0xc0
 [<c03d99da>] start_kernel+0x2aa/0x2f0
 [<c03d9140>] unknown_bootoption+0x0/0x1f0
 =======================
eth2: no IPv6 routers present

-- 
Pete Clements