LKML Archive on lore.kernel.org
help / color / mirror / Atom feed
From: Catalin Marinas <catalin.marinas@arm.com>
To: Murali Karicheri <m-karicheri2@ti.com>
Cc: Robin Murphy <Robin.Murphy@arm.com>,
	"devicetree@vger.kernel.org" <devicetree@vger.kernel.org>,
	Russell King <linux@arm.linux.org.uk>,
	Arnd Bergmann <arnd@arndb.de>,
	"linux-pci@vger.kernel.org" <linux-pci@vger.kernel.org>,
	Joerg Roedel <joro@8bytes.org>, Will Deacon <Will.Deacon@arm.com>,
	"linux-kernel@vger.kernel.org" <linux-kernel@vger.kernel.org>,
	"grant.likely@linaro.org" <grant.likely@linaro.org>,
	"iommu@lists.linux-foundation.org"
	<iommu@lists.linux-foundation.org>,
	Rob Herring <robh+dt@kernel.org>,
	"suravee.suthikulpanit@amd.com" <suravee.suthikulpanit@amd.com>,
	Bjorn Helgaas <bhelgaas@google.com>,
	"linux-arm-kernel@lists.infradead.org" 
	<linux-arm-kernel@lists.infradead.org>
Subject: Re: [PATCH v4 3/6] of: fix size when dma-range is not used
Date: Thu, 5 Feb 2015 22:44:40 +0000	[thread overview]
Message-ID: <20150205224439.GA19250@e104818-lin.cambridge.arm.com> (raw)
In-Reply-To: <54D3E3C3.1040104@ti.com>

Murali,

On Thu, Feb 05, 2015 at 09:42:27PM +0000, Murali Karicheri wrote:
> On 02/02/2015 07:18 AM, Catalin Marinas wrote:
> > On Fri, Jan 30, 2015 at 06:06:27PM +0000, Murali Karicheri wrote:
> >> On 01/28/2015 12:30 PM, Catalin Marinas wrote:
> >>> I think we can remove this check altogether (we leaved without it for a
> >>> while) but we need to add 1 when calculating the mask:
> >>>
> >>> 	dev->coherent_dma_mask = min(DMA_BIT_MASK(32),
> >>> 				     DMA_BIT_MASK(ilog2(size + 1)));
> >>>
> >> For Keystone, the dma_addr is to be taken care as well to determine the
> >> mask. The above will not work.
> >
> > This was discussed before (not on this thread) and dma_addr should not
> > affect the mask, it only affects the pfn offset.
> >
> >> Based on the discussion so far, this is the function I have come up with
> >> incorporating the suggestions. Please review this and see if I have
> >> missed out any. This works fine on Keystone.
> >>
> >> void of_dma_configure(struct device *dev, struct device_node *np)
> >> {
> >> 	u64 dma_addr = 0, paddr, size;
> >> 	int ret;
> >> 	bool coherent;
> >> 	unsigned long offset = 0;
> >> 	struct iommu_ops *iommu;
> >>
> >> 	/*
> >> 	 * Set default size to cover the 32-bit. Drivers are expected to setup
> >> 	 * the correct size and dma_mask.
> >>     	 */
> >> 	size = 1ULL<<  32;
> >>
> >> 	ret = of_dma_get_range(np,&dma_addr,&paddr,&size);
> >> 	if (!ret) {
> >> 		offset = PFN_DOWN(paddr - dma_addr);
> >> 		if (!size) {
> >> 			dev_err(dev, "Invalid size (%llx)\n",
> >> 				size);
> >> 			return;
> >> 		}
> >> 		if (size&  1) {
> >> 			size = size + 1;
> >> 			dev_warn(dev, "Incorrect usage of size (%llx)\n",
> >> 				 size);
> >> 		}
> >> 		dev_dbg(dev, "dma_pfn_offset(%#08lx)\n", offset);
> >> 	}
> >> 	dev->dma_pfn_offset = offset;
> >>
> >> 	/*
> >> 	 * Coherent DMA masks larger than 32-bit must be explicitly set by the
> >> 	 * driver.
> >> 	 */
> >> 	dev->coherent_dma_mask = min(DMA_BIT_MASK(32),
> >> 				     DMA_BIT_MASK(ilog2(dma_addr + size)));
> >
> > That's not correct, coherent_dma_mask should still be calculated solely
> > based on size, not dma_addr.
> >
> > Functions like swiotlb_dma_supported() use phys_to_dma() which on ARM
> > (32-bit) subtracts the dma_pfn_offset, so the mask based on size works
> > fine.
> >
> > In the arm64 tree, we haven't taken dma_pfn_offset into account for
> > phys_to_dma() yet but if needed for a SoC, we'll add it.
> 
> The size based dma mask calculation itself can be a separate topic 
> patch. This series is adding important fix to get the PCI driver 
> functional and I would like to get this merged as soon as possible.

Well as long as you don't break the existing users of
of_dma_configure() ;).

> I also want to hear from Arnd about yout comment as we had discussed
> this in the initial discussion of this patch series and 8/8 is
> essentially added based on that discussion. I will add a simple check
> to catch and warn the incorrect size setting in DT for dma-range as
> suggested by Rob Herring and create a new patch to for size based mask
> calculation. I will be sending v6 (expected to be merged soon) today
> and will work to add a new patch. Before that we need to agree on what
> is the content of the patch.
> 
> 1. On keystone, DMA address start at 0x8000_0000 and DMA-able memory is 
> 2G from the above base address. So without taking into account the
> dma_addr, mask calculated will be 0x7fff_ffff where as we need that to 
> be 0xffff_ffff for keystone. So need to use this in the calculation.

Ah, you are right. I confused dma_addr in your patch with the offset.

> 2. W.r.t arm_pfn_offset, this was added to support Keystone as the DDR 
> physical address for LPAE startes at 0x8_0000_0000 and the pfn offset is 
> calculated as the PFN of (0x8_0000_0000 - 0x8000_0000) to do the dma 
> address to DDR address translation.

Indeed.

I'll look at your patches again tomorrow.

-- 
Catalin

  reply	other threads:[~2015-02-05 22:44 UTC|newest]

Thread overview: 45+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
2015-01-23 22:32 [PATCH v4 0/6] PCI: get DMA configuration from parent device Murali Karicheri
2015-01-23 22:32 ` [PATCH v4 1/6] of: iommu: add ptr to OF node arg to of_iommu_configure() Murali Karicheri
2015-01-25 13:32   ` Laurent Pinchart
2015-01-26 18:49     ` Murali Karicheri
2015-01-28 11:33       ` Will Deacon
2015-01-28 12:23         ` Laurent Pinchart
2015-01-28 12:29           ` Will Deacon
2015-01-28 13:15             ` Laurent Pinchart
2015-01-28 13:32               ` Will Deacon
2015-01-28 15:21                 ` Murali Karicheri
2015-01-28 23:32                 ` Laurent Pinchart
2015-01-29 14:59                   ` Murali Karicheri
2015-01-29 16:49                   ` Rob Herring
2015-01-30  0:24                     ` Laurent Pinchart
2015-01-30 15:23                       ` Murali Karicheri
2015-01-23 22:32 ` [PATCH v4 2/6] of: move of_dma_configure() to device.c to help re-use Murali Karicheri
2015-01-23 22:32 ` [PATCH v4 3/6] of: fix size when dma-range is not used Murali Karicheri
2015-01-27 11:27   ` Robin Murphy
2015-01-27 15:44     ` Murali Karicheri
2015-01-27 18:55     ` Murali Karicheri
2015-01-28 11:05       ` Catalin Marinas
2015-01-28 15:45         ` Rob Herring
2015-01-28 17:23           ` Catalin Marinas
2015-01-28 17:34           ` Murali Karicheri
2015-01-28 15:55         ` Robin Murphy
2015-01-28 17:30           ` Catalin Marinas
2015-01-30 18:06             ` Murali Karicheri
2015-02-02 12:18               ` Catalin Marinas
2015-02-02 16:10                 ` Murali Karicheri
2015-02-05 21:42                 ` Murali Karicheri
2015-02-05 22:44                   ` Catalin Marinas [this message]
2015-01-23 22:32 ` [PATCH v4 4/6] of/pci: add of_pci_dma_configure() update dma configuration Murali Karicheri
2015-01-23 23:41   ` Bjorn Helgaas
2015-01-26 23:25     ` Murali Karicheri
2015-01-26 23:59       ` Bjorn Helgaas
2015-01-27 18:14         ` Murali Karicheri
2015-01-27 18:42           ` Bjorn Helgaas
2015-01-27 18:45             ` Murali Karicheri
2015-01-23 22:32 ` [PATCH v4 5/6] PCI: update dma configuration from DT Murali Karicheri
2015-01-23 23:27   ` Bjorn Helgaas
2015-01-26 23:28     ` Murali Karicheri
2015-01-23 22:32 ` [PATCH v4 6/6] arm: dma-mapping: updates to limit dma_mask and iommu mapping size Murali Karicheri
2015-01-27 11:12   ` Robin Murphy
2015-01-27 11:34     ` Catalin Marinas
2015-01-27 15:19       ` Murali Karicheri

Reply instructions:

You may reply publicly to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \
    --in-reply-to=20150205224439.GA19250@e104818-lin.cambridge.arm.com \
    --to=catalin.marinas@arm.com \
    --cc=Robin.Murphy@arm.com \
    --cc=Will.Deacon@arm.com \
    --cc=arnd@arndb.de \
    --cc=bhelgaas@google.com \
    --cc=devicetree@vger.kernel.org \
    --cc=grant.likely@linaro.org \
    --cc=iommu@lists.linux-foundation.org \
    --cc=joro@8bytes.org \
    --cc=linux-arm-kernel@lists.infradead.org \
    --cc=linux-kernel@vger.kernel.org \
    --cc=linux-pci@vger.kernel.org \
    --cc=linux@arm.linux.org.uk \
    --cc=m-karicheri2@ti.com \
    --cc=robh+dt@kernel.org \
    --cc=suravee.suthikulpanit@amd.com \
    --subject='Re: [PATCH v4 3/6] of: fix size when dma-range is not used' \
    /path/to/YOUR_REPLY

  https://kernel.org/pub/software/scm/git/docs/git-send-email.html

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link

This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).