LKML Archive on lore.kernel.org
help / color / mirror / Atom feed
From: Boris Brezillon <boris.brezillon@bootlin.com>
To: Stefan Agner <stefan@agner.ch>
Cc: mark.rutland@arm.com, benjamin.lindqvist@endian.se,
pgaikwad@nvidia.com, dev@lynxeye.de, mirza.krak@gmail.com,
richard@nod.at, pdeschrijver@nvidia.com,
linux-kernel@vger.kernel.org, krzk@kernel.org,
jonathanh@nvidia.com, marek.vasut@gmail.com,
devicetree@vger.kernel.org, robh+dt@kernel.org,
thierry.reding@gmail.com, marcel@ziswiler.com,
miquel.raynal@bootlin.com, linux-tegra@vger.kernel.org,
linux-mtd@lists.infradead.org, Dmitry Osipenko <digetx@gmail.com>,
computersforpeace@gmail.com, dwmw2@infradead.org
Subject: Re: [PATCH v3 4/6] mtd: rawnand: add NVIDIA Tegra NAND Flash controller driver
Date: Sat, 9 Jun 2018 08:46:15 +0200 [thread overview]
Message-ID: <20180609084615.6fba31ec@bbrezillon> (raw)
In-Reply-To: <20180609084157.0c2f12e6@bbrezillon>
On Sat, 9 Jun 2018 08:41:57 +0200
Boris Brezillon <boris.brezillon@bootlin.com> wrote:
> On Sat, 09 Jun 2018 08:23:51 +0200
> Stefan Agner <stefan@agner.ch> wrote:
>
> > On 09.06.2018 07:52, Boris Brezillon wrote:
> > > On Fri, 08 Jun 2018 23:51:01 +0200
> > > Stefan Agner <stefan@agner.ch> wrote:
> > >
> > >
> > >> >
> > >> > void tegra_nand_controller_reset(struct tegra_nand_controller *ctrl)
> > >> > {
> > >> > int err;
> > >> >
> > >> > disable_irq(ctrl->irq);
> > >> >
> > >> > err = reset_control_reset(ctrl->rst);
> > >> > if (err) {
> > >> > dev_err(ctrl->dev, "Failed to reset HW: %d\n", err);
> > >> > msleep(HW_TIMEOUT);
> > >> > }
> > >> >
> > >> > writel_relaxed(NAND_CMD_STATUS, ctrl->regs + HWSTATUS_CMD);
> > >> > writel_relaxed(HWSTATUS_MASK, ctrl->regs + HWSTATUS_MASK);
> > >> > writel_relaxed(INT_MASK, ctrl->regs + ISR);
> > >>
> > >> If we do a controller reset, there is much more state than that which
> > >> needs to be restored. A lot of it is not readily available currently
> > >> (timing, ECC settings...)
> > >
> > > This is actually a good test to detect what is not properly initialized
> > > by the driver. Timings should be configured correctly through
> > > ->setup_data_interface(). ECC engine should be disabled by default and
> > > only enabled when ->{read,write}_page() is called.
> > >
> >
> > Is setup_data_interface guaranteed to be called after a failed
> > ->exec_op()/{read,write}_page()?
>
> No. Maybe I misunderstood when tegra_nand_controller_reset() was
> supposed to be called. That's something I would call only once, early
> in the probe function, so that the controller is placed in a well-known
> state before we start using it. Definitely not something you should
> call after each error.
Note that if you really want to reset the controller after an error,
you should also iterate over all chips and call nand_reset() on them.
next prev parent reply other threads:[~2018-06-09 6:46 UTC|newest]
Thread overview: 41+ messages / expand[flat|nested] mbox.gz Atom feed top
2018-05-31 22:16 [PATCH v3 0/6] mtd: rawnand: add NVIDIA Tegra NAND flash support Stefan Agner
2018-05-31 22:16 ` [PATCH v3 1/6] mtd: rawnand: add Reed-Solomon error correction algorithm Stefan Agner
2018-06-01 7:26 ` Boris Brezillon
2018-06-01 9:25 ` Boris Brezillon
2018-06-01 13:34 ` Stefan Agner
2018-06-01 13:43 ` Boris Brezillon
2018-05-31 22:16 ` [PATCH v3 2/6] mtd: rawnand: add an option to specify NAND chip as a boot device Stefan Agner
2018-06-01 7:26 ` Boris Brezillon
2018-06-05 20:11 ` Rob Herring
2018-06-06 7:28 ` Boris Brezillon
2018-05-31 22:16 ` [PATCH v3 3/6] mtd: rawnand: tegra: add devicetree binding Stefan Agner
2018-06-01 7:30 ` Boris Brezillon
2018-06-05 20:19 ` Dmitry Osipenko
2018-06-06 10:39 ` Thierry Reding
2018-06-06 10:45 ` Boris Brezillon
2018-06-06 11:07 ` Thierry Reding
2018-06-06 12:14 ` Stefan Agner
2018-06-06 12:31 ` Boris Brezillon
2018-06-05 20:13 ` Rob Herring
2018-05-31 22:16 ` [PATCH v3 4/6] mtd: rawnand: add NVIDIA Tegra NAND Flash controller driver Stefan Agner
2018-06-01 9:20 ` Dmitry Osipenko
2018-06-08 21:51 ` Stefan Agner
2018-06-09 5:52 ` Boris Brezillon
2018-06-09 6:23 ` Stefan Agner
2018-06-09 6:41 ` Boris Brezillon
2018-06-09 6:46 ` Boris Brezillon [this message]
2018-06-09 6:55 ` Boris Brezillon
2018-06-09 6:51 ` Stefan Agner
2018-06-09 12:21 ` Dmitry Osipenko
2018-06-10 11:09 ` Stefan Agner
2018-06-10 15:00 ` Dmitry Osipenko
2018-06-10 15:32 ` Boris Brezillon
2018-06-11 11:45 ` Dmitry Osipenko
2018-06-11 11:50 ` Boris Brezillon
2018-06-11 13:10 ` Dmitry Osipenko
2018-06-04 17:16 ` Randolph Maaßen
2018-06-04 20:56 ` Stefan Agner
2018-06-09 5:55 ` Boris Brezillon
2018-06-09 7:18 ` Boris Brezillon
2018-05-31 22:16 ` [PATCH v3 5/6] ARM: dts: tegra: add Tegra20 NAND flash controller node Stefan Agner
2018-05-31 22:16 ` [PATCH v3 6/6] ARM: dts: tegra: enable NAND flash on Colibri T20 Stefan Agner
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20180609084615.6fba31ec@bbrezillon \
--to=boris.brezillon@bootlin.com \
--cc=benjamin.lindqvist@endian.se \
--cc=computersforpeace@gmail.com \
--cc=dev@lynxeye.de \
--cc=devicetree@vger.kernel.org \
--cc=digetx@gmail.com \
--cc=dwmw2@infradead.org \
--cc=jonathanh@nvidia.com \
--cc=krzk@kernel.org \
--cc=linux-kernel@vger.kernel.org \
--cc=linux-mtd@lists.infradead.org \
--cc=linux-tegra@vger.kernel.org \
--cc=marcel@ziswiler.com \
--cc=marek.vasut@gmail.com \
--cc=mark.rutland@arm.com \
--cc=miquel.raynal@bootlin.com \
--cc=mirza.krak@gmail.com \
--cc=pdeschrijver@nvidia.com \
--cc=pgaikwad@nvidia.com \
--cc=richard@nod.at \
--cc=robh+dt@kernel.org \
--cc=stefan@agner.ch \
--cc=thierry.reding@gmail.com \
--subject='Re: [PATCH v3 4/6] mtd: rawnand: add NVIDIA Tegra NAND Flash controller driver' \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).