[PATCH 3/4] net: ll_temac: Cleanup multicast filter on change

[Esben Haabendal <esben@geanix.com>]

Avoid leaving old address table entries when using multicast.  If more than
one multicast address were removed, only the first removed address would
actually be cleared.

Signed-off-by: Esben Haabendal <esben@geanix.com>
---
 drivers/net/ethernet/xilinx/ll_temac_main.c | 7 +++++--
 1 file changed, 5 insertions(+), 2 deletions(-)

diff --git a/drivers/net/ethernet/xilinx/ll_temac_main.c b/drivers/net/ethernet/xilinx/ll_temac_main.c
index 9d43be3..75da604 100644
--- a/drivers/net/ethernet/xilinx/ll_temac_main.c
+++ b/drivers/net/ethernet/xilinx/ll_temac_main.c
@@ -484,10 +484,13 @@ static void temac_set_multicast_list(struct net_device *ndev)
 						    multi_addr_lsw);
 			i++;
 		}
-	} else {
+	}
+
+	/* Clear all or remaining/unused address table entries */
+	while (i < MULTICAST_CAM_TABLE_NUM) {
 		temac_indirect_out32_locked(lp, XTE_MAW0_OFFSET, 0);
 		temac_indirect_out32_locked(lp, XTE_MAW1_OFFSET, i << 16);
-		}
+		i++;
 	}
 
 	/* Enable address filter block if currently disabled */
-- 
2.4.11