[PATCH v3 4/6] ARM: at91/dt: sama5d3: add i2c gpio pinctrl

[Codrin Ciubotariu <codrin.ciubotariu@microchip.com>]

From: Kamel Bouhara <kamel.bouhara@bootlin.com>

Add the i2c gpio pinctrls to support the i2c bus recovery

Signed-off-by: Kamel Bouhara <kamel.bouhara@bootlin.com>
[codrin.ciubotariu@microchip.com: removed gpio pull-ups]
Signed-off-by: Codrin Ciubotariu <codrin.ciubotariu@microchip.com>
---

Changes in v3:
 - removed gpio pull-ups;

Changes in v2:
  - none;

 arch/arm/boot/dts/sama5d3.dtsi | 33 ++++++++++++++++++++++++++++++---
 1 file changed, 30 insertions(+), 3 deletions(-)

diff --git a/arch/arm/boot/dts/sama5d3.dtsi b/arch/arm/boot/dts/sama5d3.dtsi
index f770aace0efd..1cea2137decf 100644
--- a/arch/arm/boot/dts/sama5d3.dtsi
+++ b/arch/arm/boot/dts/sama5d3.dtsi
@@ -159,8 +159,11 @@
 				dmas = <&dma0 2 AT91_DMA_CFG_PER_ID(7)>,
 				       <&dma0 2 AT91_DMA_CFG_PER_ID(8)>;
 				dma-names = "tx", "rx";
-				pinctrl-names = "default";
+				pinctrl-names = "default", "gpio";
 				pinctrl-0 = <&pinctrl_i2c0>;
+				pinctrl-1 = <&pinctrl_i2c0_gpio>;
+				sda-gpios = <&pioA 30 GPIO_ACTIVE_HIGH>;
+				scl-gpios = <&pioA 31 GPIO_ACTIVE_HIGH>;
 				#address-cells = <1>;
 				#size-cells = <0>;
 				clocks = <&twi0_clk>;
@@ -174,8 +177,11 @@
 				dmas = <&dma0 2 AT91_DMA_CFG_PER_ID(9)>,
 				       <&dma0 2 AT91_DMA_CFG_PER_ID(10)>;
 				dma-names = "tx", "rx";
-				pinctrl-names = "default";
+				pinctrl-names = "default", "gpio";
 				pinctrl-0 = <&pinctrl_i2c1>;
+				pinctrl-1 = <&pinctrl_i2c1_gpio>;
+				sda-gpios = <&pioC 26 GPIO_ACTIVE_HIGH>;
+				scl-gpios = <&pioC 27 GPIO_ACTIVE_HIGH>;
 				#address-cells = <1>;
 				#size-cells = <0>;
 				clocks = <&twi1_clk>;
@@ -357,8 +363,11 @@
 				dmas = <&dma1 2 AT91_DMA_CFG_PER_ID(11)>,
 				       <&dma1 2 AT91_DMA_CFG_PER_ID(12)>;
 				dma-names = "tx", "rx";
-				pinctrl-names = "default";
+				pinctrl-names = "default", "gpio";
 				pinctrl-0 = <&pinctrl_i2c2>;
+				pinctrl-1 = <&pinctrl_i2c2_gpio>;
+				sda-gpios = <&pioA 18 GPIO_ACTIVE_HIGH>;
+				scl-gpios = <&pioA 19 GPIO_ACTIVE_HIGH>;
 				#address-cells = <1>;
 				#size-cells = <0>;
 				clocks = <&twi2_clk>;
@@ -639,6 +648,12 @@
 							<AT91_PIOA 30 AT91_PERIPH_A AT91_PINCTRL_NONE	/* PA30 periph A TWD0 pin, conflicts with URXD1, ISI_VSYNC */
 							 AT91_PIOA 31 AT91_PERIPH_A AT91_PINCTRL_NONE>;	/* PA31 periph A TWCK0 pin, conflicts with UTXD1, ISI_HSYNC */
 					};
+
+					pinctrl_i2c0_gpio: i2c0-gpio {
+						atmel,pins =
+							<AT91_PIOA 30 AT91_PERIPH_GPIO AT91_PINCTRL_NONE
+							 AT91_PIOA 31 AT91_PERIPH_GPIO AT91_PINCTRL_NONE>;
+					};
 				};
 
 				i2c1 {
@@ -647,6 +662,12 @@
 							<AT91_PIOC 26 AT91_PERIPH_B AT91_PINCTRL_NONE	/* PC26 periph B TWD1 pin, conflicts with SPI1_NPCS1, ISI_D11 */
 							 AT91_PIOC 27 AT91_PERIPH_B AT91_PINCTRL_NONE>;	/* PC27 periph B TWCK1 pin, conflicts with SPI1_NPCS2, ISI_D10 */
 					};
+
+					pinctrl_i2c1_gpio: i2c1-gpio {
+						atmel,pins =
+							<AT91_PIOC 26 AT91_PERIPH_GPIO AT91_PINCTRL_NONE
+							 AT91_PIOC 27 AT91_PERIPH_GPIO AT91_PINCTRL_NONE>;
+					};
 				};
 
 				i2c2 {
@@ -655,6 +676,12 @@
 							<AT91_PIOA 18 AT91_PERIPH_B AT91_PINCTRL_NONE	/* TWD2 pin, conflicts with LCDDAT18, ISI_D2 */
 							 AT91_PIOA 19 AT91_PERIPH_B AT91_PINCTRL_NONE>; /* TWCK2 pin, conflicts with LCDDAT19, ISI_D3 */
 					};
+
+					pinctrl_i2c2_gpio: i2c2-gpio {
+						atmel,pins =
+							<AT91_PIOA 18 AT91_PERIPH_GPIO AT91_PINCTRL_NONE
+							 AT91_PIOA 19 AT91_PERIPH_GPIO AT91_PINCTRL_NONE>;
+					};
 				};
 
 				isi {
-- 
2.20.1