LKML Archive on lore.kernel.org help / color / mirror / Atom feed
From: amirmizi6@gmail.com To: Eyal.Cohen@nuvoton.com, jarkko.sakkinen@linux.intel.com, oshrialkoby85@gmail.com, alexander.steffen@infineon.com, robh+dt@kernel.org, mark.rutland@arm.com, peterhuewe@gmx.de, jgg@ziepe.ca, arnd@arndb.de, gregkh@linuxfoundation.org, benoit.houyere@st.com, eajames@linux.ibm.com, joel@jms.id.au Cc: devicetree@vger.kernel.org, linux-kernel@vger.kernel.org, linux-integrity@vger.kernel.org, oshri.alkoby@nuvoton.com, tmaimon77@gmail.com, gcwilson@us.ibm.com, kgoldman@us.ibm.com, Dan.Morav@nuvoton.com, oren.tanami@nuvoton.com, shmulik.hager@nuvoton.com, amir.mizinski@nuvoton.com, Amir Mizinski <amirmizi6@gmail.com> Subject: [PATCH v13 2/7] tpm: tpm_tis: Fix expected bit handling and send all bytes in one shot without last byte in exception Date: Thu, 26 Aug 2021 14:19:03 +0300 [thread overview] Message-ID: <20210826111908.117278-3-amirmizi6@gmail.com> (raw) In-Reply-To: <20210826111908.117278-1-amirmizi6@gmail.com> From: Amir Mizinski <amirmizi6@gmail.com> Detected the following incorrect implementation of the send command: polling on the TPM_STS.stsValid field followed by checking the TPM_STS.expect field only once. Since TPM_STS.stsValid represents the TPM_STS.expect validity, both fields should be polled at the same time. This fix modifies the signature of 'wait_for_tpm_stat()', adding an additional "mask_result" parameter to its call and renaming it to 'tpm_tis_wait_for_stat()' for better alignment with other naming. 'tpm_tis_wait_for_stat()' is now polling the TPM_STS with a mask and waits for the value in mask_result. The fix adds the ability to check if certain TPM_STS bits have been cleared. This change is also aligned to verifying the CRC on I2C TPM. The CRC verification should be done after the TPM_STS.expect field is cleared (TPM received all expected command bytes and set the calculated CRC value in the register). In addition, the send command was changed to comply with TCG_DesignPrinciples_TPM2p0Driver_vp24_pubrev.pdf as follows: - send all command bytes in one loop - remove special handling of the last byte Suggested-by: Benoit Houyere <benoit.houyere@st.com> Signed-off-by: Amir Mizinski <amirmizi6@gmail.com> Reviewed-by: Jarkko Sakkinen <jarkko.sakkinen@linux.intel.com> --- drivers/char/tpm/tpm_tis_core.c | 70 +++++++++++++++-------------------------- 1 file changed, 26 insertions(+), 44 deletions(-) diff --git a/drivers/char/tpm/tpm_tis_core.c b/drivers/char/tpm/tpm_tis_core.c index 69579ef..b34e59b 100644 --- a/drivers/char/tpm/tpm_tis_core.c +++ b/drivers/char/tpm/tpm_tis_core.c @@ -44,9 +44,9 @@ static bool wait_for_tpm_stat_cond(struct tpm_chip *chip, u8 mask, return false; } -static int wait_for_tpm_stat(struct tpm_chip *chip, u8 mask, - unsigned long timeout, wait_queue_head_t *queue, - bool check_cancel) +static int tpm_tis_wait_for_stat(struct tpm_chip *chip, u8 mask, u8 stat, + unsigned long timeout, + wait_queue_head_t *queue, bool check_cancel) { unsigned long stop; long rc; @@ -55,7 +55,7 @@ static int wait_for_tpm_stat(struct tpm_chip *chip, u8 mask, /* check current status */ status = chip->ops->status(chip); - if ((status & mask) == mask) + if ((status & mask) == stat) return 0; stop = jiffies + timeout; @@ -83,7 +83,7 @@ static int wait_for_tpm_stat(struct tpm_chip *chip, u8 mask, usleep_range(TPM_TIMEOUT_USECS_MIN, TPM_TIMEOUT_USECS_MAX); status = chip->ops->status(chip); - if ((status & mask) == mask) + if ((status & mask) == stat) return 0; } while (time_before(jiffies, stop)); } @@ -259,10 +259,11 @@ static int recv_data(struct tpm_chip *chip, u8 *buf, size_t count) int size = 0, burstcnt, rc; while (size < count) { - rc = wait_for_tpm_stat(chip, - TPM_STS_DATA_AVAIL | TPM_STS_VALID, - chip->timeout_c, - &priv->read_queue, true); + rc = tpm_tis_wait_for_stat(chip, + TPM_STS_DATA_AVAIL | TPM_STS_VALID, + TPM_STS_DATA_AVAIL | TPM_STS_VALID, + chip->timeout_c, &priv->read_queue, + true); if (rc < 0) return rc; burstcnt = get_burstcount(chip); @@ -315,8 +316,9 @@ static int tpm_tis_recv(struct tpm_chip *chip, u8 *buf, size_t count) goto out; } - if (wait_for_tpm_stat(chip, TPM_STS_VALID, chip->timeout_c, - &priv->int_queue, false) < 0) { + if (tpm_tis_wait_for_stat(chip, TPM_STS_VALID, TPM_STS_VALID, + chip->timeout_c, &priv->int_queue, + false) < 0) { size = -ETIME; goto out; } @@ -342,61 +344,40 @@ static int tpm_tis_send_data(struct tpm_chip *chip, const u8 *buf, size_t len) struct tpm_tis_data *priv = dev_get_drvdata(&chip->dev); int rc, status, burstcnt; size_t count = 0; - bool itpm = priv->flags & TPM_TIS_ITPM_WORKAROUND; status = tpm_tis_status(chip); if ((status & TPM_STS_COMMAND_READY) == 0) { tpm_tis_ready(chip); - if (wait_for_tpm_stat - (chip, TPM_STS_COMMAND_READY, chip->timeout_b, - &priv->int_queue, false) < 0) { + if (tpm_tis_wait_for_stat(chip, TPM_STS_COMMAND_READY, + TPM_STS_COMMAND_READY, + chip->timeout_b, &priv->int_queue, + false) < 0) { rc = -ETIME; goto out_err; } } - while (count < len - 1) { + while (count < len) { burstcnt = get_burstcount(chip); if (burstcnt < 0) { dev_err(&chip->dev, "Unable to read burstcount\n"); rc = burstcnt; goto out_err; } - burstcnt = min_t(int, burstcnt, len - count - 1); + burstcnt = min_t(int, burstcnt, len - count); rc = tpm_tis_write_bytes(priv, TPM_DATA_FIFO(priv->locality), burstcnt, buf + count); if (rc < 0) goto out_err; count += burstcnt; - - if (wait_for_tpm_stat(chip, TPM_STS_VALID, chip->timeout_c, - &priv->int_queue, false) < 0) { - rc = -ETIME; - goto out_err; - } - status = tpm_tis_status(chip); - if (!itpm && (status & TPM_STS_DATA_EXPECT) == 0) { - rc = -EIO; - goto out_err; - } } - - /* write last byte */ - rc = tpm_tis_write8(priv, TPM_DATA_FIFO(priv->locality), buf[count]); - if (rc < 0) - goto out_err; - - if (wait_for_tpm_stat(chip, TPM_STS_VALID, chip->timeout_c, - &priv->int_queue, false) < 0) { + if (tpm_tis_wait_for_stat(chip, TPM_STS_VALID | TPM_STS_DATA_EXPECT, + TPM_STS_VALID, chip->timeout_a, + &priv->int_queue, false) < 0) { rc = -ETIME; goto out_err; } - status = tpm_tis_status(chip); - if (!itpm && (status & TPM_STS_DATA_EXPECT) != 0) { - rc = -EIO; - goto out_err; - } return 0; @@ -451,9 +432,10 @@ static int tpm_tis_send_main(struct tpm_chip *chip, const u8 *buf, size_t len) ordinal = be32_to_cpu(*((__be32 *) (buf + 6))); dur = tpm_calc_ordinal_duration(chip, ordinal); - if (wait_for_tpm_stat - (chip, TPM_STS_DATA_AVAIL | TPM_STS_VALID, dur, - &priv->read_queue, false) < 0) { + if (tpm_tis_wait_for_stat(chip, + TPM_STS_DATA_AVAIL | TPM_STS_VALID, + TPM_STS_DATA_AVAIL | TPM_STS_VALID, + dur, &priv->read_queue, false) < 0) { rc = -ETIME; goto out_err; } -- 2.7.4
next prev parent reply other threads:[~2021-08-26 12:19 UTC|newest] Thread overview: 16+ messages / expand[flat|nested] mbox.gz Atom feed top 2021-08-26 11:19 [PATCH v13 0/7] Add tpm i2c ptp driver amirmizi6 2021-08-26 11:19 ` [PATCH v13 1/7] tpm: Make read{16, 32}() and write32() in tpm_tis_phy_ops optional amirmizi6 2021-08-26 15:57 ` Jarkko Sakkinen 2021-08-26 11:19 ` amirmizi6 [this message] 2021-08-26 15:59 ` [PATCH v13 2/7] tpm: tpm_tis: Fix expected bit handling and send all bytes in one shot without last byte in exception Jarkko Sakkinen 2021-08-26 11:19 ` [PATCH v13 3/7] tpm: tpm_tis: Rewrite "tpm_tis_req_canceled()" amirmizi6 2021-08-26 16:01 ` Jarkko Sakkinen 2021-08-26 11:19 ` [PATCH v13 4/7] tpm: Handle an exception for TPM Firmware Update mode amirmizi6 2021-08-26 16:02 ` Jarkko Sakkinen 2021-08-26 11:19 ` [PATCH v13 5/7] tpm: tpm_tis: verify TPM_STS register is valid after locality request amirmizi6 2021-08-26 16:03 ` Jarkko Sakkinen 2021-08-26 11:19 ` [PATCH v13 6/7] tpm: tpm_tis: add tpm_tis_i2c driver amirmizi6 2021-08-26 16:04 ` Jarkko Sakkinen 2021-08-26 11:19 ` [PATCH v13 7/7] tpm: Add YAML schema for TPM TIS I2C options amirmizi6 2021-08-26 13:26 ` Rob Herring 2021-08-26 16:05 ` Jarkko Sakkinen
Reply instructions: You may reply publicly to this message via plain-text email using any one of the following methods: * Save the following mbox file, import it into your mail client, and reply-to-all from there: mbox Avoid top-posting and favor interleaved quoting: https://en.wikipedia.org/wiki/Posting_style#Interleaved_style * Reply using the --to, --cc, and --in-reply-to switches of git-send-email(1): git send-email \ --in-reply-to=20210826111908.117278-3-amirmizi6@gmail.com \ --to=amirmizi6@gmail.com \ --cc=Dan.Morav@nuvoton.com \ --cc=Eyal.Cohen@nuvoton.com \ --cc=alexander.steffen@infineon.com \ --cc=amir.mizinski@nuvoton.com \ --cc=arnd@arndb.de \ --cc=benoit.houyere@st.com \ --cc=devicetree@vger.kernel.org \ --cc=eajames@linux.ibm.com \ --cc=gcwilson@us.ibm.com \ --cc=gregkh@linuxfoundation.org \ --cc=jarkko.sakkinen@linux.intel.com \ --cc=jgg@ziepe.ca \ --cc=joel@jms.id.au \ --cc=kgoldman@us.ibm.com \ --cc=linux-integrity@vger.kernel.org \ --cc=linux-kernel@vger.kernel.org \ --cc=mark.rutland@arm.com \ --cc=oren.tanami@nuvoton.com \ --cc=oshri.alkoby@nuvoton.com \ --cc=oshrialkoby85@gmail.com \ --cc=peterhuewe@gmx.de \ --cc=robh+dt@kernel.org \ --cc=shmulik.hager@nuvoton.com \ --cc=tmaimon77@gmail.com \ /path/to/YOUR_REPLY https://kernel.org/pub/software/scm/git/docs/git-send-email.html * If your mail client supports setting the In-Reply-To header via mailto: links, try the mailto: linkBe sure your reply has a Subject: header at the top and a blank line before the message body.
This is a public inbox, see mirroring instructions for how to clone and mirror all data and code used for this inbox; as well as URLs for NNTP newsgroup(s).