Re: [PATCH v10 0/7] i2c: Add FSI-attached I2C master algorithm

[Andy Shevchenko <andy.shevchenko@gmail.com>]

On Wed, Jun 13, 2018 at 10:36 PM, Eddie James
<eajames@linux.vnet.ibm.com> wrote:
> This series adds an algorithm for an I2C master physically located on an FSI
> slave device. The I2C master has multiple ports, each of which may be connected
> to an I2C slave. Access to the I2C master registers is achieved over FSI bus.
>
> Due to the multi-port nature of the I2C master, the driver instantiates a new
> I2C adapter for each port connected to a slave. The connected ports should be
> defined in the device tree under the I2C master device.
>

You missed to include tag I gave

Reviewed-by: Andy Shevchenko <andy.shevchenko@gmail.com>

be careful next time.

> Changes since v9
>  - Switch the status masks to use a combination of bits rather than directly
>    coding the value
>  - Remove the interrupt mask definition as it was unused
>  - Fixed return value of master_xfer function (return number of xfrs, not 0)
>
> Changes since v8
>  - Drop unecessary else statements
>  - Use i++ instead of ++i
>  - Use kzalloc/kfree instead of devm_kzalloc/devm_kfree for port structure
>  - Drop the list_empty check in remove
>
> Changes since v7
>  - Fix grammer in Kconfig (a -> an)
>  - Change I2C registers to use BIT and GENMASK
>  - Remove custom macros and use FIELD_PREP and FIELD_GET
>  - Fix a few unecessary initializations and "return rc" that are always zero
>  - Clean up the read/write fifo functions a bit
>  - Few other clean-up items
>
> Changes since v6
>  - Remove spinlock for reset functionality; it's unecessary and doesn't work
>    with the latest FSI core.
>  - Use a mutex instead of a semaphore, and don't wait for timeout to get the
>    lock.
>  - Use usleeps instead of schedule_timeout; it's not worth the overhead when
>    the wait should be very short in between sending the command and receiving
>    the response.
>
> Changes since v5
>  - Fix reset functionality and do a reset after every transfer failure
>
> Eddie James (7):
>   dt-bindings: i2c: Add FSI-attached I2C master dt binding documentation
>   i2c: Add FSI-attached I2C master algorithm
>   i2c: fsi: Add port structures
>   i2c: fsi: Add abort and hardware reset procedures
>   i2c: fsi: Add transfer implementation
>   i2c: fsi: Add I2C master locking
>   i2c: fsi: Add bus recovery
>
>  Documentation/devicetree/bindings/i2c/i2c-fsi.txt |  40 ++
>  drivers/i2c/busses/Kconfig                        |  11 +
>  drivers/i2c/busses/Makefile                       |   1 +
>  drivers/i2c/busses/i2c-fsi.c                      | 727 ++++++++++++++++++++++
>  4 files changed, 779 insertions(+)
>  create mode 100644 Documentation/devicetree/bindings/i2c/i2c-fsi.txt
>  create mode 100644 drivers/i2c/busses/i2c-fsi.c
>
> --
> 1.8.3.1
>



-- 
With Best Regards,
Andy Shevchenko