LKML Archive on lore.kernel.org help / color / mirror / Atom feed
From: Rob Herring <robh+dt@kernel.org> To: Johan Hovold <johan@kernel.org> Cc: Greg Kroah-Hartman <gregkh@linuxfoundation.org>, Mark Rutland <mark.rutland@arm.com>, Andreas Kemnade <andreas@kemnade.info>, Arnd Bergmann <arnd@arndb.de>, "H . Nikolaus Schaller" <hns@goldelico.com>, Pavel Machek <pavel@ucw.cz>, "linux-kernel@vger.kernel.org" <linux-kernel@vger.kernel.org>, devicetree@vger.kernel.org Subject: Re: [PATCH 6/7] dt-bindings: gnss: add sirfstar binding Date: Wed, 25 Apr 2018 13:25:26 -0500 [thread overview] Message-ID: <CAL_Jsq+nj9P5z=Ao=UbS-AKy+qeM98EFJiHmYgoniD_4N3Hr4w@mail.gmail.com> (raw) In-Reply-To: <20180424163458.11947-7-johan@kernel.org> On Tue, Apr 24, 2018 at 11:34 AM, Johan Hovold <johan@kernel.org> wrote: > Add binding for SiRFstar-based GNSS receivers. > > Note that while four compatible-strings are initially added representing > devices which differ in which I/O interfaces they support, they > otherwise essentially share the same feature set. > > Pin and supply names (and some recommended timings) vary slightly, but > the binding recommends using a common set of names. > > Note that the wakeup gpio is not intended to be as a wakeup source, but > rather to detect the current power state of the device (active or > hibernate). > > Signed-off-by: Johan Hovold <johan@kernel.org> > --- > .../devicetree/bindings/gnss/sirfstar.txt | 38 +++++++++++++++++++ > .../devicetree/bindings/vendor-prefixes.txt | 3 ++ > 2 files changed, 41 insertions(+) > create mode 100644 Documentation/devicetree/bindings/gnss/sirfstar.txt One nit below, otherwise: Reviewed-by: Rob Herring <robh@kernel.org> > diff --git a/Documentation/devicetree/bindings/gnss/sirfstar.txt b/Documentation/devicetree/bindings/gnss/sirfstar.txt > new file mode 100644 > index 000000000000..5e6a02aec49a > --- /dev/null > +++ b/Documentation/devicetree/bindings/gnss/sirfstar.txt > @@ -0,0 +1,38 @@ > +SiRFstar-based GNSS Receiver DT binding > + > +SiRFstar chipsets are used in GNSS-receiver modules produced by several > +vendors and can use UART, SPI or I2C interfaces. > + > +Please see Documentation/devicetree/bindings/gnss/gnss.txt for generic > +properties. > + > +Required Properties: > + > +- compatible : Must be one of > + > + "fastrax,uc430" > + "linx,r4" > + "wi2wi,w2sg0008i" > + "wi2wi,w2sg0084i" > + > +- vcc-supply : Main voltage regulator (3V3_IN, VDD, VCC) > + > +Optional Properties: > + > +- enable-gpios : GPIO used to power on and off device (ON_OFF) > +- wakeup-gpios : GPIO used to determine device power state (WAKEUP, RFPWRUP) > +- timepulse-gpios : Timepulse (e.g 1PPS) GPIO (1PPS, TM) > + > +Example: > + > +serial@1234 { > + compatible = "ns16550a"; > + > + gnss { > + compatible = "wi2wi,w2sg0084i"; > + > + vcc-supply = <&gnss_reg>; > + enable-gpios = <&gpio0 16 GPIO_ACTIVE_HIGH>; > + wakeup-gpios = <&gpio0 17 GPIO_ACTIVE_HIGH>; > + }; > +}; > diff --git a/Documentation/devicetree/bindings/vendor-prefixes.txt b/Documentation/devicetree/bindings/vendor-prefixes.txt > index 2128dfdf73f1..ddd81c82082d 100644 > --- a/Documentation/devicetree/bindings/vendor-prefixes.txt > +++ b/Documentation/devicetree/bindings/vendor-prefixes.txt > @@ -120,6 +120,7 @@ excito Excito > ezchip EZchip Semiconductor > fairphone Fairphone B.V. > faraday Faraday Technology Corporation > +fastrax Fastrax Oy > fcs Fairchild Semiconductor > firefly Firefly > focaltech FocalTech Systems Co.,Ltd > @@ -197,6 +198,7 @@ licheepi Lichee Pi > linaro Linaro Limited > linksys Belkin International, Inc. (Linksys) > linux Linux-specific binding > +linx Linx Technologies > lltc Linear Technology Corporation > lsi LSI Corp. (LSI Logic) > lwn Liebherr-Werk Nenzing GmbH > @@ -390,6 +392,7 @@ vivante Vivante Corporation > vocore VoCore Studio > voipac Voipac Technologies s.r.o. > vot Vision Optical Technology Co., Ltd. > +wi2wi Wi2Wi Wrong spot. > wd Western Digital Corp. > wetek WeTek Electronics, limited. > wexler Wexler > -- > 2.17.0 >
next prev parent reply other threads:[~2018-04-25 18:25 UTC|newest] Thread overview: 86+ messages / expand[flat|nested] mbox.gz Atom feed top 2018-04-24 16:34 [PATCH 0/7] gnss: add new GNSS subsystem Johan Hovold 2018-04-24 16:34 ` [PATCH 1/7] gnss: add GNSS receiver subsystem Johan Hovold 2018-04-25 8:56 ` Greg Kroah-Hartman 2018-04-25 10:56 ` Johan Hovold 2018-04-25 12:23 ` Johan Hovold 2018-04-29 13:35 ` Greg Kroah-Hartman 2018-05-02 7:57 ` Johan Hovold 2018-04-24 16:34 ` [PATCH 2/7] dt-bindings: add generic gnss binding Johan Hovold 2018-04-25 18:26 ` Rob Herring 2018-04-24 16:34 ` [PATCH 3/7] gnss: add generic serial driver Johan Hovold 2018-04-25 8:57 ` Greg Kroah-Hartman 2018-04-25 10:58 ` Johan Hovold 2018-04-25 9:00 ` Greg Kroah-Hartman 2018-04-25 11:05 ` Johan Hovold 2018-04-24 16:34 ` [PATCH 4/7] dt-bindings: gnss: add u-blox binding Johan Hovold 2018-04-25 18:16 ` Rob Herring 2018-04-26 9:10 ` Johan Hovold 2018-05-01 14:05 ` Rob Herring 2018-05-02 8:16 ` Johan Hovold 2018-05-02 13:16 ` Rob Herring 2018-05-07 9:06 ` Johan Hovold 2018-05-03 9:35 ` H. Nikolaus Schaller 2018-05-03 18:50 ` Andreas Kemnade 2018-05-04 5:16 ` H. Nikolaus Schaller 2018-05-04 11:42 ` Sebastian Reichel 2018-05-04 12:04 ` H. Nikolaus Schaller 2018-05-04 13:37 ` Sebastian Reichel 2018-05-04 14:29 ` Tony Lindgren 2018-05-07 10:07 ` Johan Hovold 2018-05-07 10:01 ` Johan Hovold 2018-05-07 15:45 ` Tony Lindgren 2018-05-07 16:34 ` Johan Hovold 2018-05-07 17:50 ` Tony Lindgren 2018-05-08 6:58 ` Johan Hovold 2018-05-08 15:22 ` Tony Lindgren 2018-05-08 15:47 ` Tony Lindgren 2018-05-08 15:54 ` Tony Lindgren 2018-05-08 16:49 ` Tony Lindgren 2018-05-09 13:10 ` OMAP serial runtime PM and autosuspend (was: Re: [PATCH 4/7] dt-bindings: gnss: add u-blox binding)) Johan Hovold 2018-05-09 13:57 ` Tony Lindgren 2018-05-17 10:09 ` Johan Hovold 2018-05-17 17:10 ` Tony Lindgren 2018-05-21 13:48 ` Johan Hovold 2018-05-21 15:48 ` Tony Lindgren 2018-05-24 9:17 ` Johan Hovold 2018-05-24 13:32 ` Tony Lindgren 2018-05-25 14:02 ` Johan Hovold 2018-05-08 15:56 ` [PATCH 4/7] dt-bindings: gnss: add u-blox binding Sebastian Reichel 2018-05-09 9:18 ` Serdev runtime PM (was: Re: [PATCH 4/7] dt-bindings: gnss: add u-blox binding) Johan Hovold 2018-05-09 9:49 ` Johan Hovold 2018-05-09 14:05 ` Tony Lindgren 2018-05-17 10:25 ` Johan Hovold 2018-05-07 9:47 ` [PATCH 4/7] dt-bindings: gnss: add u-blox binding Johan Hovold 2018-04-24 16:34 ` [PATCH 5/7] gnss: add driver for u-blox receivers Johan Hovold 2018-04-24 16:34 ` [PATCH 6/7] dt-bindings: gnss: add sirfstar binding Johan Hovold 2018-04-25 18:25 ` Rob Herring [this message] 2018-04-26 9:12 ` Johan Hovold 2018-04-24 16:34 ` [PATCH 7/7] gnss: add driver for sirfstar-based receivers Johan Hovold 2018-04-24 17:40 ` [PATCH 0/7] gnss: add new GNSS subsystem H. Nikolaus Schaller 2018-04-24 17:50 ` Johan Hovold 2018-04-24 19:44 ` H. Nikolaus Schaller 2018-04-25 8:11 ` Johan Hovold 2018-04-26 10:10 ` H. Nikolaus Schaller 2018-04-26 18:21 ` Johan Hovold 2018-04-24 20:13 ` Pavel Machek 2018-04-24 20:59 ` Andreas Kemnade 2018-04-25 7:32 ` Johan Hovold 2018-04-25 6:49 ` Marcel Holtmann 2018-04-25 7:24 ` Johan Hovold 2018-04-24 20:38 ` Pavel Machek 2018-04-25 6:26 ` Pavel Machek 2018-04-25 6:51 ` Johan Hovold 2018-04-25 8:48 ` Greg Kroah-Hartman 2018-04-25 10:31 ` Johan Hovold 2018-05-04 13:27 ` Sebastian Reichel 2018-05-04 20:03 ` Pavel Machek 2018-05-05 17:28 ` Sebastian Reichel 2018-05-05 21:11 ` Pavel Machek 2018-05-06 6:47 ` Marcel Holtmann 2018-05-07 10:20 ` Johan Hovold 2018-05-07 19:06 ` Marcel Holtmann 2018-05-08 7:01 ` Johan Hovold 2018-05-08 7:49 ` Marcel Holtmann 2018-05-08 12:48 ` Johan Hovold 2018-05-08 20:03 ` Marcel Holtmann 2018-05-30 10:26 ` Johan Hovold
Reply instructions: You may reply publicly to this message via plain-text email using any one of the following methods: * Save the following mbox file, import it into your mail client, and reply-to-all from there: mbox Avoid top-posting and favor interleaved quoting: https://en.wikipedia.org/wiki/Posting_style#Interleaved_style * Reply using the --to, --cc, and --in-reply-to switches of git-send-email(1): git send-email \ --in-reply-to='CAL_Jsq+nj9P5z=Ao=UbS-AKy+qeM98EFJiHmYgoniD_4N3Hr4w@mail.gmail.com' \ --to=robh+dt@kernel.org \ --cc=andreas@kemnade.info \ --cc=arnd@arndb.de \ --cc=devicetree@vger.kernel.org \ --cc=gregkh@linuxfoundation.org \ --cc=hns@goldelico.com \ --cc=johan@kernel.org \ --cc=linux-kernel@vger.kernel.org \ --cc=mark.rutland@arm.com \ --cc=pavel@ucw.cz \ /path/to/YOUR_REPLY https://kernel.org/pub/software/scm/git/docs/git-send-email.html * If your mail client supports setting the In-Reply-To header via mailto: links, try the mailto: linkBe sure your reply has a Subject: header at the top and a blank line before the message body.
This is a public inbox, see mirroring instructions for how to clone and mirror all data and code used for this inbox; as well as URLs for NNTP newsgroup(s).