Re: [PATCH 09/21] arm64: dts: allwinner: a64: Add HDMI support

[Jagan Teki <jagan@amarulasolutions.com>]

On Mon, May 14, 2018 at 2:10 PM, Maxime Ripard
<maxime.ripard@bootlin.com> wrote:
> On Mon, May 14, 2018 at 02:03:36PM +0530, Jagan Teki wrote:
>> On Wed, May 2, 2018 at 5:04 PM, Maxime Ripard <maxime.ripard@bootlin.com> wrote:
>> > Hi,
>> >
>> > On Mon, Apr 30, 2018 at 05:10:46PM +0530, Jagan Teki wrote:
>> >> +             hdmi_phy: hdmi-phy@1ef0000 {
>> >> +                     compatible = "allwinner,sun50i-a64-hdmi-phy",
>> >> +                                  "allwinner,sun8i-h3-hdmi-phy";
>> >> +                     reg = <0x01ef0000 0x10000>;
>> >> +                     clocks = <&ccu CLK_BUS_HDMI>, <&ccu CLK_HDMI_DDC>,
>> >> +                              <&ccu CLK_PLL_VIDEO1>;
>> >
>> > You were discussing that the PLL0 could also be used to clock the PHY,
>> > has that been figured out?
>>
>> This is what I understand from Fig: 3-3. Module Clock Diagram, both
>> tcon0 and tcon1 are using HDMI. I'm thinking based on the tcon
>> configuration we need use proper PLL or some logic to get common PLL
>> don't know yet. Since this series adding tcon1 I've attached PLL1.
>
> You're not describing the TCON node here though, but the HDMI one, and
> the HDMI block is listed in both the PLL video 0 and 1.

So how can we attach particular PLL with particular HDMI(PLL0 to HDMI0
and so-on) or do we need to attached both the PLL's any suggestion?