LKML Archive on lore.kernel.org
help / color / mirror / Atom feed
From: Bjorn Andersson <bjorn.andersson@linaro.org>
To: Bjorn Helgaas <helgaas@kernel.org>
Cc: Prasad Malisetty <pmaliset@codeaurora.org>,
	agross@kernel.org, bhelgaas@google.com, robh+dt@kernel.org,
	swboyd@chromium.org, lorenzo.pieralisi@arm.com,
	svarbanov@mm-sol.com, devicetree@vger.kernel.org,
	linux-arm-msm@vger.kernel.org, linux-usb@vger.kernel.org,
	linux-kernel@vger.kernel.org, dianders@chromium.org,
	mka@chromium.org, vbadigan@codeaurora.org,
	sallenki@codeaurora.org
Subject: Re: [PATCH v4 4/4] PCIe: qcom: Add support to control pipe clk src
Date: Fri, 16 Jul 2021 15:38:50 -0500	[thread overview]
Message-ID: <YPHuWudai/FO6SMN@yoga> (raw)
In-Reply-To: <20210716150646.GA2098485@bjorn-Precision-5520>

On Fri 16 Jul 10:06 CDT 2021, Bjorn Helgaas wrote:

> Run this:
> 
>   $ git log --oneline drivers/pci/controller/dwc/pcie-qcom.c
> 
> and make your subject match the style and structure (in particular,
> s/PCIe/PCI/).  In this case, maybe something like this?
> 
>   PCI: qcom: Switch sc7280 gcc_pcie_1_pipe_clk_src after PHY init
> 
> On Fri, Jul 16, 2021 at 07:28:47PM +0530, Prasad Malisetty wrote:
> > This is a new requirement for sc7280 SoC.
> > To enable gdsc gcc_pcie_1_pipe_clk_src should be TCXO.
> > after PHY initialization gcc_pcie_1_pipe_clk_src needs
> > to switch from TCXO to gcc_pcie_1_pipe_clk.
> 
> This says what *needs* to happen, but it doesn't actually say what
> this patch *does*.  I think it's something like:
> 
>   On the sc7280 SoC, the clock source for pcie_1_pipe must be the TCXO
>   while gdsc is enabled.  But after the PHY is initialized, the clock
>   source must be switched to gcc_pcie_1_pipe_clk.
> 
>   On sc7280, switch gcc_pcie_1_pipe_clk_src from TCXO to
>   gcc_pcie_1_pipe_clk after the PHY has been initialized.
> 
> Nits: Rewrap to fill 75 columns or so.  Add blank lines between
> paragraphs.  Start sentences with capital letter.
> 
> > Signed-off-by: Prasad Malisetty <pmaliset@codeaurora.org>
> > ---
> >  drivers/pci/controller/dwc/pcie-qcom.c | 22 ++++++++++++++++++++++
> >  1 file changed, 22 insertions(+)
> > 
> > diff --git a/drivers/pci/controller/dwc/pcie-qcom.c b/drivers/pci/controller/dwc/pcie-qcom.c
> > index 8a7a300..9e0e4ab 100644
> > --- a/drivers/pci/controller/dwc/pcie-qcom.c
> > +++ b/drivers/pci/controller/dwc/pcie-qcom.c
> > @@ -166,6 +166,9 @@ struct qcom_pcie_resources_2_7_0 {
> >  	struct regulator_bulk_data supplies[2];
> >  	struct reset_control *pci_reset;
> >  	struct clk *pipe_clk;
> > +	struct clk *gcc_pcie_1_pipe_clk_src;
> > +	struct clk *phy_pipe_clk;
> > +	struct clk *ref_clk_src;
> >  };
> >  
> >  union qcom_pcie_resources {
> > @@ -1167,6 +1170,20 @@ static int qcom_pcie_get_resources_2_7_0(struct qcom_pcie *pcie)
> >  	if (ret < 0)
> >  		return ret;
> >  
> > +	if (of_device_is_compatible(dev->of_node, "qcom,pcie-sc7280")) {
> > +		res->gcc_pcie_1_pipe_clk_src = devm_clk_get(dev, "pipe_mux");
> > +		if (IS_ERR(res->gcc_pcie_1_pipe_clk_src))
> > +			return PTR_ERR(res->gcc_pcie_1_pipe_clk_src);
> > +
> > +		res->phy_pipe_clk = devm_clk_get(dev, "phy_pipe");
> > +		if (IS_ERR(res->phy_pipe_clk))
> > +			return PTR_ERR(res->phy_pipe_clk);
> > +
> > +		res->ref_clk_src = devm_clk_get(dev, "ref");
> > +		if (IS_ERR(res->ref_clk_src))
> > +			return PTR_ERR(res->ref_clk_src);
> 
> Not clear why ref_clk_src is here, since it's not used anywhere.  If
> it's not necessary here, drop it and add it in a future patch that
> uses it.
> 
> > +	}
> > +
> >  	res->pipe_clk = devm_clk_get(dev, "pipe");
> >  	return PTR_ERR_OR_ZERO(res->pipe_clk);
> >  }
> > @@ -1255,6 +1272,11 @@ static void qcom_pcie_deinit_2_7_0(struct qcom_pcie *pcie)
> >  static int qcom_pcie_post_init_2_7_0(struct qcom_pcie *pcie)
> >  {
> >  	struct qcom_pcie_resources_2_7_0 *res = &pcie->res.v2_7_0;
> > +	struct dw_pcie *pci = pcie->pci;
> > +	struct device *dev = pci->dev;
> > +
> > +	if (of_device_is_compatible(dev->of_node, "qcom,pcie-sc7280"))
> 
> Using of_device_is_compatible() follows existing style in the driver,
> which is good.  But I'm not sure that's good style in general because
> it's a little repetitious and wasteful.
> 

Following the style is good, but up until the recent sm8250 addition it
was just a hack to deal with legacy platforms that we don't know the
exact details about.

But, all platforms I know of has the pipe_clk from the PHY fed into the
pipe_clk_src mux in the gcc block and then ends up in the PCIe
controller. As such, I suspect that the pipe_clk handling should be moved
to the common code path of the driver and there's definitely no harm in
making sure that the pipe_clk_src mux is explicitly configured on
existing platforms (at least all 2.7.0 based ones).

> qcom_pcie_probe() already calls of_device_get_match_data(), which does
> basically the same thing as of_device_is_compatible(), so I think we
> could take better advantage of that by augmenting struct qcom_pcie_ops
> with these device-specific details.
> 

I agree.

Regards,
Bjorn

> Some drivers that use this strategy:
> 
>   drivers/pci/controller/cadence/pci-j721e.c
>   drivers/pci/controller/dwc/pci-imx6.c
>   drivers/pci/controller/dwc/pci-layerscape.c
>   drivers/pci/controller/dwc/pci-layerscape-ep.c
>   drivers/pci/controller/dwc/pcie-tegra194.c
>   drivers/pci/controller/pci-ftpci100.c
>   drivers/pci/controller/pcie-brcmstb.c
>   drivers/pci/controller/pcie-mediatek.c
> 
> > +		clk_set_parent(res->gcc_pcie_1_pipe_clk_src, res->phy_pipe_clk);
> >  
> >  	return clk_prepare_enable(res->pipe_clk);
> >  }
> > -- 
> > The Qualcomm Innovation Center, Inc. is a member of the Code Aurora Forum,
> > a Linux Foundation Collaborative Project
> > 

  reply	other threads:[~2021-07-16 20:39 UTC|newest]

Thread overview: 22+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
2021-07-16 13:58 [PATCH v4 0/4] Add DT bindings and DT nodes for PCIe and PHY in SC7280 Prasad Malisetty
2021-07-16 13:58 ` [PATCH v4 1/4] dt-bindings: pci: qcom: Document PCIe bindings for SC720 Prasad Malisetty
2021-07-16 19:27   ` Stephen Boyd
2021-07-20  6:56     ` Prasad Malisetty
2021-07-16 13:58 ` [PATCH v4 2/4] arm64: dts: qcom: sc7280: Add PCIe and PHY related nodes Prasad Malisetty
2021-07-16 19:31   ` Stephen Boyd
2021-07-20  6:54     ` Prasad Malisetty
2021-08-02 19:23   ` Matthias Kaehlcke
2021-08-17  8:05     ` Prasad Malisetty
2021-07-16 13:58 ` [PATCH v4 3/4] arm64: dts: qcom: sc7280: Add PCIe nodes for IDP board Prasad Malisetty
2021-07-16 19:32   ` Stephen Boyd
2021-07-20  6:57     ` Prasad Malisetty
2021-07-16 13:58 ` [PATCH v4 4/4] PCIe: qcom: Add support to control pipe clk src Prasad Malisetty
2021-07-16 15:06   ` Bjorn Helgaas
2021-07-16 20:38     ` Bjorn Andersson [this message]
2021-07-20 11:28       ` Prasad Malisetty
2021-08-09 17:09       ` Prasad Malisetty
2021-07-16 19:37   ` Stephen Boyd
2021-07-16 20:31     ` Bjorn Andersson
2021-07-16 21:39       ` Stephen Boyd
2021-07-16 22:11         ` Bjorn Andersson
2021-07-16 14:29 ` [PATCH v4 0/4] Add DT bindings and DT nodes for PCIe and PHY in SC7280 Bjorn Helgaas

Reply instructions:

You may reply publicly to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \
    --in-reply-to=YPHuWudai/FO6SMN@yoga \
    --to=bjorn.andersson@linaro.org \
    --cc=agross@kernel.org \
    --cc=bhelgaas@google.com \
    --cc=devicetree@vger.kernel.org \
    --cc=dianders@chromium.org \
    --cc=helgaas@kernel.org \
    --cc=linux-arm-msm@vger.kernel.org \
    --cc=linux-kernel@vger.kernel.org \
    --cc=linux-usb@vger.kernel.org \
    --cc=lorenzo.pieralisi@arm.com \
    --cc=mka@chromium.org \
    --cc=pmaliset@codeaurora.org \
    --cc=robh+dt@kernel.org \
    --cc=sallenki@codeaurora.org \
    --cc=svarbanov@mm-sol.com \
    --cc=swboyd@chromium.org \
    --cc=vbadigan@codeaurora.org \
    --subject='Re: [PATCH v4 4/4] PCIe: qcom: Add support to control pipe clk src' \
    /path/to/YOUR_REPLY

  https://kernel.org/pub/software/scm/git/docs/git-send-email.html

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link

This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).